Posts by Atsel02

Yes i know the hdd isn't working properly because it recognizes the other one but it also keeps rebooting with both one.

Thanks for the reply
At first I though it was the hdd but after changing it the problem did not solve. However it booted completely after some tryes with the "new" hdd but now it does the same as before. Now I have another problem, the bios does not detect the original hdd, it detects the CD reader but not the hdd, so I will try to plug it in a pc and copying all to the "new" drive to see if when it boots I can make the robot move.

https://goo.gl/images/Huih52
Inside the case there are two parts, the upper one that has all the leds for the voltages, and the bottom one, that has leds for the axis and the watchdog. In my controller all the leds on the upper part are on, but all the ones on the lower part are off, and I dont know if they sould be on or if they turn on when you start moving the robot.

Hello, I hope someone can help me here.
I have a kuka kc1 controller at the school, it boots to windows fine until it says "starting technology", then windows starts rebooting. I managed to boot up completely two times, but it says that it needs to shut down and it also shows messages saying that there are no axis found. I have tried another hdd, motherboard, ram, processor and expansion cards from other controller but I havent touched any of the other internal components. I have also noticed that the bottom controller board does not have any LED's on, I dont know if that's normal