I sometime get random error with the serial communication, in the end everything work but those error dont seem to have any impact on the file transfer.
Might just be some kind of noise on the comm line???
I sometime get random error with the serial communication, in the end everything work but those error dont seem to have any impact on the file transfer.
Might just be some kind of noise on the comm line???
Hi guys, just a little follow up about my issue, now everything is working and i'm able to communicate with the controller flawlesly.
I felt a bit dum when i realised that i forgot to install enet on the controller when i reinitialised the software.
If you have some problem, start by installing the right software, it will help a lot!!! LOL
Anyway thank you guys for your help
Could you help me find this manual somewhere
Thanks
Thank for your reply.
Well, im confused right now about the rj2 ethernet fonctionality because i have the tcp/ip, motet, ftp and devicenet option installed and i can setup the tcp/ip and ftp setting in the host comm menu.
I am able to start a client or server on tcp/ip and ftp protocol so why would those protocol would be available in the setting?
Thanks for your reply.
Hi guys, i need your help to setup my fanuc rj2 controller with a ab-rio ethernet board.
I have the controller running and the ethernet/ftp/motet option installed.
I want to setup a ethernet connection over the 10base2 port on the ab-rio board. Does anybody here have some documentation or tips on how to setup the client/server setting?
I tried to start a server on the rj2 but i receive an error telling me the server failed to start but i dont know why.
Do i need some additionnal hardware or software?
I know that the controller was previously setup with devicenet and it was working fine.
So any help from you guys would be appreciated.
Thanks
Ok thanks, i'll try that
Never saw that before but i would check for controller cabinet wire short to gound somewhere, might be around your estop board
Hi guys, i'm working with a arcmate 100 rj2 controller.
i'm trying to do some offline programming with it but did not found a way to compile my .tp with the right version.
My rj2 is version 4.40 and my version of winolpc will not go lower then (rj3 V 5.3)
My question is: is there some of you that have heard about a winolpc that will support th rj2 4.40 version?
when i try to load a .tp file from V5.3 i got the LANG-006 error
any help fro you would be appreciated.
Thanks
Hi guys, i'm having a hard time establishing a serial connection on a Rj2 system.
I have tried every serial port (p2,p3, p4) and none of them seem yo work.
I dont know if it is a software or hardware related problem, i tried every configuration on the port init, and comm option.
What i would like to know if there is another way to test the serial port, if the cpu need repair, i'll send it out but i want to have some advice from you before send anything out.
Is there a variable in the system that could disable the serial port on the rj2?
The system used to have a devicenet network setup but it is not used anymore, can it be part of my problem?
Thank you guys in advance for your help
hi, i woud lie to know if you could send me copy of kfloppy too, i've been looking for it for omme time now
psta@bell.net
thank's a LOT
Hi guys, i'm having some problem with a r-j2 controller, it might be simple for some of you guys here but i'm kind of lost right now, i've been messing with it for a couple days so far and nothing seem to be working.
I'm trying to setup a connection via the serial rs-232 port with a pc and it just dont seem to work.
one thing that i'd like to understand is how can a tcp/ip protocol can communicate trough a serial com port?
thank's guys in advance for your coming help