May I have your email?
Posts by valkamar
-
-
Please send it APS EDIT
-
-
Hi ROBOPROF,
There is an inscription on the dashboard
SYSTEM
bat
alm
there is a light diode available that does not light up.
Is the battery in this board?
-
When I turn on the pendant I should get these messages without looking at any menu. at the top right end of the pendant. The batteries have not been changed for more than 5 years!
Can you detail how to locate these batteries in the controller.
-
When are the batteries changed when the controller is on or off?
It is known where the robot's battery is, but not clear about the controller.
Does it indicate that it is due for replacement?
-
They have been emailed!
-
Will these files / I sent them / become reinstallable?
-
Yeah, that's exactly what I was worried about.
If I put small standard batteries corresponding to voltage and 1500 mili amps? I have seen this on the forum installed outside.
-
Thanks Robodk,
Where is the SK16 battery located, when should it be replaced, so as not to lose memory and require a reinstallation. I know about the robot, but I don't know where it is on the CONTROLLER.
-
This battery for 24v. and with the machine on do they have to be replaced?
I have emailed the files I have.
-
OK.
I will do everything you suggested.
I already have a virtual machine, a few details remain to be read on it and I connect to the robot/this laptop has COMРORT/
It will be more difficult with rechargeable batteries!
Can I have a temporary solution with batteries or external 24v. How many amperes does it draw?
-
I am writing from Sofia, Bulgaria
-
I can't upload the photos!
Give an email if possible
-
-
There is an inscription next to the orange lamp
BATTERY. A red light glowed in the upper left corner.
After replacing 3 pcs. 1.5v batteries each with controller on, orange and red lights gone.
I don't know about 24v rechargeable batteries. If there are any, they have long since been replaced - the robot has not been turned on for more than 4 years.
-
No. First I turned on the controller and I see an orange battery light. As you say - I had to leave it on for 12-20 hours to charge.
Out of ignorance, I made a gross mistake, turned off the controller, replaced 3 pcs. batteries 1.5v,
Error Z 217 appeared again on power on,
EMERGENCY STOP, ALERX STOP
This is what I think about reinstalling KSS.
If there is another solution that would be great.
It lost MASTERING, I can't fix it because the robot doesn't move. BAD
-
How do I find a second starting position?
Where is this main menu?
-
This is exactly what happened to me as SkyeFire said
It has not been connected to the power supply for a long time, the battery of the controller turns on after a few minutes of disconnection, which leads to the loss of Mastering and henceforth PAIN, and a big one. Maybe a reinstallation of KSS is next because there is an energy stop and the robot does not move! I don't know any other solution.
-
Robot in the Main Menu.
How to find : Robot in the main menu:
Advertising from our partners
