Hello friends
How did you solve your problem?
Posts by sergeysalnikov_71
-
-
All right. this is the big problem. a large number of parts and bends. I think this can be done with RSI with top knife position control - BendTech worked on that.
-
I greet you dear friends.
How can you realize the work of a robot with a bending machine? What kind of software is needed for this on the robot? Previously (KCC 8.2-8.3) KUKA.BendTech was used, but it is no longer available for order.
-
Hello
We have an old fanuc robot (r30ia) and we decided to install the profinet extension on it. For this purchased cp1604. How to do the settings further - there is no information.
Tell me how to install / configure the robot for this extension. Thank you -
-
hi!
where can I configure which input the touch signal will come from?
where to go on techpedant?
-
The description helped a lot. thank.
What bus are in the basic version of the controller? or are all installed optionally? -
Hello!!
I'm beginner programmer robots Kawasaki.
I need help: How to connect the I/O module (Bus Coupler Device-Net) to the robot?
Describe the procedure.Thanks!
-
Thanks!
But in the instructions there is no answer to my question: which line is transmitted, with the node name or not?
The file that you attached I plan to use as a base. -
is attached
-
Hello.
Tell me what line does the robot send / receive?
For example:
<Message>Example message</Message>
or
Example messageDoes anyone have a source server for sharing information?
-
Hi.
How to remove the message about the maintenance of KRC2(put a mark in the journal)?
Thank