hmm those other ways are definitely a solution ......
Posts by Wili22
-
-
Hi everybody
I need help, How I turn off information system message from VisionTech version 4.2. Error code: VTH00001. Test message: "Not enough features recognized to determine the location of the part" Robor KRC4 KSS 8.6
The message shows on robot panel when the camera dont find the part, and then I change the exposure time and try find part again, but the camera cannot find the part, robot shows this massage again. And i dont now stoped the message. because i change the exposure time until the camera find the part.
Thank you
-
why N1 KSD 48 only N1 ?
-
hi
Need help
my robot KUKA kr210/L150 with KRC2 version V5.4.14
When i want snapping ( measure) TCP or otherwise the robot motion after some time robot stop and show message "2962 P_15 Acknowledge general KSD-error A1" and next message "1239 P_15 Acknowledge Error synchronization drive module A1" this indicates for all axses
when I acknowledge this Report in a moment messages are back? with this problem is robot unusableCould you help me with this problem???
Excuse my English
-
System write a problem in line with Expononet (X_PLUS[I+1]=2^I) and I is varaibles .... how is corect writing ?
DECL INT X_PLUS[8],I
FOR I=0 TO 7
IF $IN[I]=TRUE THEN
X_PLUS[I+1]=2^I
ELSE
X_PLUS[I+1]=0
ENDIF
ENDFOR
SUCETX_PLUS=X_PLUS[1]+X_PLUS[2]+X_PLUS[3]+X_PLUS[4]+X_PLUS[5]+X_PLUS[6]+X_PLUS[7]+X_PLUS[8]
PTP ={POS:X SUCETX_PLUS}