Posts by jebinthomasraju

we are using only short weld.it occurs randomly not at particular position like start of weld or end of the weld.i attached trace evaluation for the reference

it happens on every weld cycle but occurrence is random

kuka service personal was configured so there is no doubt in that. its brand new machine and process was working properly.no changes were made.every time when this message(current missing, ignition error strategy)came robot stops and thus welding.

i am using kuka kr6 robot with krc4 controller and lorch welding machine s3 robo mig.while welding robot stops welding with a message current missing
ignition error strategy and keep on position.whats the reason behind this

does any one has installed lorch welding machine with comau

i have one comau robot and i want to integrate with lorch weding machine .is it possible

i am having beckoff el6752 bus coupler for devicenet communication.is it possible to configure in fanuc robot arcmate controller.

i need to interface fanuc arcmate100ic robot with lorch welding machine through device net .is it possible