Thanks, I will try this out and hopefully I'll be able to master it.
Posts by Alexander85500
-
-
-
How do i see the communication error?
And how do i fix it?
Do i have to change some cable connections?
The input number is 1. -
This is all it says when i try to move it or press any
relevant butto. -
How can i set $MOVE_ENABLE =true?
I dont know where to find this option. -
The protocol should be profibus and i already tried
to reset lO driver but without any result.The problem ist that i dont have so many details about
the robots setup that i could give to you.
I dont know if the photo is any help because
its all german.And thanks for the anwser
-
Hello guys,
i have a problem with my kuka robot and I hope that this community is the solution for that.
I got myself a Kuka robot with a KR C2 edition 2005 controller.It was never really used because the guy who builded the whole system around the robot was
not really god in his job. However, now i can do with the Robot what i want and i want to
get it going!And here is the Problem:
Every time when i want to move one of it's axles it gives me an error message
: 1376 Active commands inhibited" And I'am always in Teach mode 1 or 2.I don't know how to solve this problem.
The only thing i could think of is that the note i get always at the beginning could
have something to do with that.
On the top of the window there is always the first "error" : 6503 Configuration error l/O driver DN2DRV".
I connected the X11 in standard way. I hope
I just want to see the Robot moving.I hope some of you might have a solution for my problem.
(Sorry for my english but I'm from germany and stil young)