Posts by byrol
-
-
Same problem of my robot. I try System\Variables\ $OP Work\$UOP Home Disable or O/1 and robot ON\OFF start HOT START. And UOP signals is DISABLE. I've solved the problem this way.
-
The software has everything that you want? Do you need just some files?
-
I found english documents.. Problems solved.
Thank you everyone.. -
dha,
Auto Error Recovery Option, which line variables? -
I tell my robot there is a problem. It looks only one Register in the register section. I can't add anything else. How Can I add more point register PR[] ?
-
Hi mack,
I need VK360 controller VRS1B english manual.. You can help me? -
I found the document. Problems solved..
-
HawkME Thank you,
I tried but the result is still the same. Now I'm trying a different method.
Regards... -
Hi everyone,
I need any manual for KUKA VK360 with controller VRS1B. -
I want to open the backed up files on the computer. For example, DIOCFGSV.IO , SYSVARSI.SV I want to see the contents of the file. Example, extension .GSD files open Notepad. Can you help?
-
najafabadi
Hello,
I need to the same documents. Manual of KUKA VK360 with controller VRS1B. Please send it to me. My mail birolanilir@gmail.com -
MUNIACO
Fanuc R-J3iC for I have many documents. Please send me your mail address. I try to help. -
Last month I set a FANUC 200IC. It says 110v on the power section. But for 220v Power selection switch in when you removed the cover of the section. Afterwards, robot-220V 50Hz with it worked flawlessly. Two hours to find it but I called.
-
Has been sharing a very useful information. Thanks to everyone.
-
ESIELI
Thank you for the reply. I'm going to try a few different.
I am grateful for your attention. -
ESIELI
Attach the magnet to the robot and remove the metal plate... -
Tie a magnet to the robot and is it possible to make the move? There is such a demand for our customers. Have tried that before? Fifth or sixth I'm afraid of damaging the engine?
-
I've had this setup for the last month. R-30iA and I/O module BMD88A1. But robot in a different city. During installation, I used these instructions. I hope that helps.
-
I had the same problem with my robot. Despite TP cable change did not improve. Finally, I would go with the grounding problem. EMG Board FUSE now not problems..