Thanks!!
Posts by txost
-
-
Hello everybody,
This is my first time with Motoman and wow! too much questions!
But, for the moment, and after reading a lot and some tries, I would like to know how to change the POSTYPE PULSE to other options. I would like to keep the points in cartesian coordenates to operate with them, or basically to change Z.
so, how can I save the point value in X,Y,Z??
Thanks
-
Hi!
If you have changed the range of the IP address, yes, you need to change according to the new configuration.
normally in Start-up menu-> Network confoguration
-
Both IP's must be on the same range, for example 192.168.1.XX, try changing these adresses!
Of course, the XX value cann't be the same!!
-
whats the IP of your laptop? and the IP of the controller?
-
insert the tool definition BEFORE the enddat
-
Are you regristered as an expert user? What did you do, "select" or "open" the program?
-
what happens if you run the program step by step?
Is the angle of the arc is bigger than 180 degrees? In this case I will do the arc in two circ instructions, for example. -
Did you TouchUp the intermediate and the finish points in the right order?
-
For get more information, how did you try to solve it?
you have some clues in your third image. Is it the first time you switch on the controller? Usually the controler has attached a quickstart guide, with a few steps to follow, I'm sure you can get the best answer there!
-
Thanks Panic for put me in the right way!
Even if i didn't get it with the msglib option (I don't understanD why), finally it is working well with the long version! Thanks!
-
yeah, sorry, it's a krc4 with KS 8.3
I hope that your information ask means it is possible to do!!
i will aldo ask how bad my english is but it's better to leave this for other time
-
Good morning,
I want to show a numeric variable value in a dialog message, for confirm or cancel other questions. I have read some documentation pdf's but I didn't found the answer. Is it possible to do it? And how?
Thanks!