Posts by Tushar_Patil

Hello,

I have a Fanuc Rj3iB robot, installed with an arc tool setup.

Weld power source is Kolarc and the communication protocol is DeviceNet. Robot is master for weld machine.

Communication is done and signals are shared between master and slave.

In weld IO setup, there is AI & AO (analog input & output) for voltage, current and wirefeed speed respectively.

But there is no analog card, weld power source is directly connected only on digital interface.

How could I get option to disable the AI & AO?

Photos are attached for your reference.

Do anyone have solution for this ? Please suggest.

can you send that robotstudio 5.14 link again over here ?

Already i had replaced touchscreen only want procedures to calibrate the touchpad

Friends,

Recently i had replaced broken touchscreen of Yrc1000 teachpendant. But after replacing it touch is not working.

Do anyone know how to calibrate touchscreen??

Thank you in advance.

Hi friends, i need some information for the shielding gas interlock for arc welding application in DX200. I had went trough the manuals, i found that output with logical number 30024 is used for gas shortage, i tried this but it turns ON in both the conditions even if there is a gas and if there is no gas. How i can i take this interlock?

Hi Bulo,
I had worked on RW 6.2, 6.3. To store the value during power failure you just have to create the new safe level and use it in the Safe Level option. The value will be stored. There is no other option to store the value after power failure.

Dear friends, i need to create a circle by using any amount of radius value

hi eureka, can you please share the snapshot of the open and close gun signals .

Than you so much

Actually i need z series operating manual and it ia not posted by any one

friends if any one having operation manual of zx130l for an application of material handling please message me.

which method is good for tip wear compensation. MeasutrewearL or RecalTcp ?
In my case i am using RecalTcp with 50 50% wear ratio. But it is not working properly.
Also for modifying some spot we need to use new electrode (cap tip) or i can do the touch-up on same wear old cap tip?

Issue solved by changing communication parameters

which method is good for tip wear compensation. MeasutrewearL or RecalTcp ?
In my case i am using RecalTcp with 50 50% wear ratio. But it is not working properly.
Also for modifying some spot we need to use new electrode (cap tip) or i can do the touch-up on same wear old cap tip?

plz check the backup, the servo motor is MU200.

My parameter are so nominal
Highest parameters are
Squezze time:, 1cycle
Hold 5 cycle
Wel1: 13 cycles
Weld2: 15 cycles
So we can see a spot is completed in 0.8 second, still it take time.

Obara with devicenet communication.

Thank yoy fluke,
Now it is 400 if i calculate it, it comes 523 rad/sec. I had increased acceleration & deceleration by 2 it is giving some result but still if we look the spot parameter the total cycle are 35 to 40 means it requires only 0.8 to 1. Sec yo execute a spot but robot holds the gun for approximately 2 sec. How it could be reduced? Any idea.

There is no one who had come across this error?

Friend, how to increase the spped of sevo gun while executing spot instruction. Currently in auto mode the spot execution is slow approx it requires 2sec for each spot and i had worked in kuka robot it requires only a second to take spit. What are the changes to be made in moc.cfg file?? Plz suggest or mail me the backup or moc file. Robot usef is 6700 with 6.2. Robotware