I found start->cold under the function button. Now it works. Thank you!
(Cold start sounded a bit scary to me as I am used to ABB where cold start is a total reset of the system where all software is deleted and need to be reinstalled).
I found start->cold under the function button. Now it works. Thank you!
(Cold start sounded a bit scary to me as I am used to ABB where cold start is a total reset of the system where all software is deleted and need to be reinstalled).
Exactly, I turned of power an turned it on again.
So cold start is the "normal" start for a Fanuc robot? But where do I chose to do a cold start? At power up, that is not in the list if I press prev and next.
I did a control start on a R30iA Mate controller today to change a parameter.
Now I cant get back to ordinary operation. I tried to repower the controller, but I do only get to control start mode again. Any idea how I solve this? I do also get a error message saying HOST-178 Router Adress Not Defined.
Does anyone have any idea about how to solve this problem? Thanks...
You solve that function by defining a system input as cycle start and one as cycle stop. They will act as the start and stop button on the pendant. I do not have the manuals avalible so I cant describe exactly how to do, but you will find it in the system manuals and not in the rapid manual.
Probably you can do something simular in the rapid code too, but it is much easier to use the system inputs.