Hi guys. I have Nachi robot AR electrical cabinet. With arm robot SF166.
Battery out, error E0010, E0052. When replacing the battery is still the error.
Looking forward to the steps you take to operate the machine.
Thank you
Posts by anthony
-
-
Thanks so much .It avtived perfected now.
-
I need to buy 10 Osacom 2000 teach pendant LCD monitors. If anyone has it please send me PM. Thanks
-
-
Thanks All
I've done it. Just clean the e.stop button on TP. -
Hi BRss
I try to move the H axis is ok but only going up but going down will disconnect the servo.
In the encoder reset only the record position and the complete key, no encoder reset key.
Thanks -
Thanks Bsrr
How to set up the encoder?
When I moved back to the standard position. The H-axis goes through a servo stop, which can only go up without going down
I followed the instructions but still can not calibrate the encoder.
Please give more details. Is it
Thank you -
Hi Skooter.
I checked E.stop buton and cable it work. test pin connect so good.measure 7-8 pin not broken.
I thinking missing jump short circuit in XIU01B ?
Somebody help now boot controller is normally but it only error PP...unpossible turn on servo. -
Thanks Robpro
I has change teach pendant and new cable other new one but not change anything so may be which CN.. it not short circuit.?? -
I don't looking the point mark position on All axis so i can not moving back standard position.
If anyones have it please share with me .because the first i working with Nachi robot .thaks so much. -
Hi all
Help me setting clear error "PP from the emegency stop in" I released E.stop buton on panel and E .stop buton on TP.- I changed a new TP Cable but it not clear this error PP.
It is HANDLING Application now it want change to ARC Application.
Someones help me ...Thanks so much -
H All
I have big problems with Nachi AW controller
- Error 0535 Position data over flow
- Error Software motion range exceeded ( S axis )
- W 1010 Robot did not execute Original Position returnPlease help .Now I can not move all axis.
Anynoes to help me .thanks -
-
i has reply pm to you
-
My Teach pendant was broken.I needing buy new ones.some ones have it please sent to me by PM.thanks all
-
My TP just be broken screen LCD. i using EXV6 controller ( OTC daihen japan)
Now i needing to buy some ones and for spares. somes ones have it please PM to me.
Thanks all. -
Hi all
I want to connect 3 station job with 3 program different for 3 station operation.but i don t have wire diagram and setting .
ex : Start buton - Hold buton - restart buton.- e.stop buton.- cancel buton - teach buton - Play buton.
Someone has experience about it .
-
Hi ..how much can you for sale ?
-
thks so much Robodoc for your reply.
-
Hi all
I have a MRC controller .after reinstalled with Arc welding apllication to make job follow some step Arc on - arc off .
but on screen PP error Alarm 5880 .
Please help me to must reinstall controller if it to missed arc alarm 9010 is ok.
thks.