Thank you for the help. I have checked all the wires all are good. That was the first step before getting on here today. All the wires ohm out nothing is shorted or broken. All contacts are clean. I will read more on the link and report my findings tomorrow
Posts by NolaJohn
-
-
I have swapped the 1AS board out with the parts machine earlier today and made no difference. ( no wires or resistors) but I will say the one with no resistor has more parts on the board
-
-
Here is a parts machine if needed
-
Not sure if this will help
-
2 more. Sorry I’m only allowed 2 pictures at a time
-
One mor picture
-
-
Still no change. With teach lock on or off / hold or run.
-
Not sure if this will work but I have attached a picture
-
Yes all the buttons work to navigate on the controller and the teach
-
No plates at all other than the AD Controller sticker on the bottom left front
-
sorry still have problems uploading pictures even from a computer. when i boot the system is comes up as a "A S- UX series" version 34f0H3-59E
-
To add to this I also see the 1GE had a red D1 (miscellaneous hardware error produced by RISC AB
-
There’s no code other that the 600
And all caps under the 600 error is
PLC COMMUNICATION ERROR
I also see inside the cabinet it appears the estp1 and estp2 have a jumper wire between them. The relay functions with Beth the estop and and teach.
On my 1BP board the EMG and LS led red lights are on
-
Just Changed them, now I get a -1601 error. No problem I can bypass with the over ride button on the door as it’s a limit switch.
Nor the next error is -600( motor power off) and still have the plc communication error
-
Back on this project. Changed the batteries and relocated them. Everything fired up seems the computer side may be ok. I have 2 error messages (err -1511 encoder battery low voltage)
PLC communication error.
-
Thank you for the tips yesterday. It gave me the courage to start taking the boards out and having a look. Bad news looks like the batteries on one board have leaked and took out 2 capacitors. I have them on order along with new batteries. I’m thinking about relocating the batteries to an easier location off the boards so this doesn’t happen again.
I will have to upload the pictures to a computer as they will not load on here via iphone
-
Thank you for the quick response. What is the best way to add a picture?
-
Hi all. I purchased 2 Kawasaki robots to use in my welding shop. I know nothing about them but was told the worked 5 years ago and have been sitting ever since. Any tips or advice before I just start running wires and start clicking buttons that I have no idea what they do. The 2 machines are a UX120 and a Js-30. They have AD controllers with teach. 1 computer has a disk in the side. Other than that it’s a guessing game of what computer goes to what machine