Thanks
Posts by alejandrofts
-
-
Hello, good morning, does anyone have information about this interface, I want to move some welding parameters, any information, a manual or notes that they have to help me understand it will help me
-
Es por spot Welder , amaneció con ese error no quiere soldar.
-
Si es el único sistema , no sé dónde ver ese contacto que si este llegando la señal
-
Help error dx200 AL-4574 LÍMITE DE TIEMPO COMPLETO DE SOLDADURA POR PUNTOS Esta alarma se produce si no se recibe ni la señal de finalización de soldadura ni la señal de error de soldadura del conductor del temporizador dentro del tiempo establecido. Subcódigo: Número de soldador < Remedio > • Encienda el contactor del temporizador. • Si la respuesta del temporizador tarda demasiado tiempo debido al diseño del sistema, aumente el tiempo establecido.
-
it is spot welding instruction is not load.
-
Could you send it to me, it would be of help, thanks.
-
But if I load my file with the same name, does it replace the routine that I already have or create another one?
-
I have downloaded mids routines and open them with notepad but if I want to make a modification how can I upload it to my dx200 controller
-
How can I know which are my inputs and outputs physically on my card they are scrambled I know the order, dx200 controller.
how to perform a correct mapping?
-
It communicates via Ethernet IP. What I want to know is how to register an address in the controller.
-
Can you help me with documents or information to be able to link a camera with the dx200 controller, it will be a keyence camera.
-
You can't do it with usb, as I have both options, you should try another format.
-
Hello, good morning. One question is that I want to make a backup of a yaskawa robot, Dx200 controller, but it does not recognize my USB. I use a 32 GB fat32 format. Should I use something different? 3080 I/O appears
-