Posts by Victortz88

I was referring to the paid features HawkME but i was incorrect and on the second attempt it all is loaded correctly now. Thanks for the help. Currently have a IRPK-217 Invalid Robot ID and no information online as to which menu it is located so that i can change it. Any help with that? Thanks

R47 I tried that and didn’t seem to work . I then tried to do a whole back up by uploading all the files but now I believe the features were not uploaded . With robo guide don’t think I can create image files . Is there a way to back it up using the dt file ? When I uploaded all the files it has a different start program on start up . But when I create a new cell with the dt file it works .

Can someone advice proper steps to restore with .dt file ? Initially disabled dcs in order to jog robot but after the reboot asked me for mastering . Decided to do a back up and found out when I clicked all of the above that it did not send over the features that were initially on robot and now have srvo 056 servo 006 servo 037 alarms . I also noticed the start up program is not the same as the original when I did the back up using this method . I soon discovered that image file was mot available on roboguide . So in short what is the suggested method or approach to restore the original set up ? All I have is all the original tp programs , .dt file and approximately 397 other files that I attempted to load into the teach pendant . Thanks

So i have backdate.dt and i want to reload that into the teach pendant . How would I do that? I am able to open it in roboguide and it is the original backup from the teach pendant but not sure how i can upload that back to teach pendant since original program was corrupted.

I changed a DCS setting and on the next power up i had a quick mastering for group 1 not set. I followed the procedure and did a set quick Master Ref . When i check the DCS Mastering parameters, the master count numbers are correct. But no position is correct. I been scrolling through the menus and see set up and ref postion. I am new to mastering and want to know what the process is . I have the old program in roboguide. would uploading the backup fix this?

I tried this dewitm but not sure if I am doing somethign wrong. My UALM do not get written to the register. Does this only work for the other alarms?

Hi, retobar. What is the name of this option. I am currently trying to add it but there is to many of them and there is no description of what they are used for. Thanks.

Thank you for previous answer. Now that I know how to add options I have an additional question.

I am trying to add the option that allows you to export points . When you right click on the controller the option click export options is not available. I guess my question is there documentation what these options are used for? How do I export Di, Do, registers, and their respective comments as a CSV? . This link is the option I am trying to add. Thanks.