Posts by bazza1000

Hi All, Flad3 is set to com3. I can change flad to com4. My laptop with USB is com4. How do I change the R-J3iB to com4 and is the cable anything special. Does flad3 support USB to 25pin rs232 on this robot. All advice would be really welcome.

Thanks, the hold signal is held high. There is a pause F1000.2 in the PMC ladder which goes to an R flag on the controller. Cannot find where F1000.2 originates.

Hi, everyone. What would cause a fanuc robot to go into a pause condition. Most probably an external/prog stop. Pendant shows AUTO paused but no obvious reason.

Hi everybody, is there a manual download that explains to an idiot, how to upload and download after editing an flad PMC program to and from a R-30iA robot controller.

HI, I am monitoring part counts on a machine. in the part display of the proface hmi it gets its data from [PLC1]%AI04322. So the variable comes from the plc which in this case is from the robot controller. The problem i have is i have the project software from all the various devices but i cannot tie up the address to anything. Can anyone help.

Hi, What is the latest version of this software. I have 6.81 installed but when i want to make a new project it only lets me select an R-30iB. if i then upload PMC to new project it tells me the Pmc data and version are different so no upload possible. I understand this because the controller i am communicating with is a R-30iA. So i am assuming i need newer software, can any one confirm this please.

Thanks for that. Daft question really but at least i got the right answer. So i got the ip address on that robot ok. If the ip address is showing **************** and the name above is saying "robot"

then how do i find the ip then?

Hi, I am using Flad 3 version 6.81. I can connect to an rb30ia controller. When i get to selection of program, content transfer (from robot to pc) and check ladder only i get the message

"because the pmc control software and the model are different, the load cannot be done."

Do i need a newer version of software.

Thanks.

When connecting with Ethernet to a hub how do I detect the address of the r30ib controller so I can upload the pmc program to PC.

Hi I need to do some ladder programming on a system controlling 4 fanuc robots. I know which one is the master but where do I actually plug in my laptop, in the robot controller or the Ethernet hub.