I asked a Fanuc welder a week ago, he was saying the cycle start is the cold start.
Posts by fc8yue27
-
-
Hello,
Trying my first plugin, created 2 karel variables. and used <ihmi type = "textboxInteger"></ihmi> generated 2 areas to enter integer values. I then used getElementById.refresh() to set the boundary. But it won't let me adding values. It is saying the range is undefined. I am not sure what information I missed. Any ideas?
Thanks beforehand!
-
Installation process was fine, no error was shown.
After uninstalled, the error,"FILE-014 File not found", showed up, Plugin list still has the plugin, and menu still showed. However, if I proceed a cold cycle start, the plugin disappeared.
Where do I check to see which files were removed and which ones were not?
-
Hello,
I am trying to make my first CRX plugin as well. This thread really helped me a lot resolving EOF issue. I have another error FILE-014 File not found when I tried to uninstall the plugin. Do you guys have any ideas what could cause it?
Thanks beforehand!
-
Hello all,
I would like to add a button and treat it as a deadman switch device enable button to hand drag cobot arm around. It is common to add an additional button onto a 6th axis of welding cobot to enable motion(device enable function). I had an old Aubo cobot, which was really easy to implement. But for this CRX 10iA/L, I could not locate the right method.
Appreciate any feedback. Thanks beforehand!
-
Thanks. I found the wiring diagram. The manual I downloaded from Fanucamerica.com was outdated, and the information got from tech support was incorrect. Rack 48 was the one to use.
-
Hello everyone,
I am very new to Fanuc robots. Last week, I received a CRX-10iA/L collaborative robot (controller is R-30ib mini plus), and trying to control DO/DI. So I wired a 24V relay to DO01 on CRMC20 terminal conversion module , with an external power supply. Configured the DO setting to rack 0, slot 0, and start 1 per Fanuc Tech support. but it is still not working.
Trying to understand what I did wrong here. Please help.
Thanks beforehand!
-
Hello Welding Panda,
I am new to Fanuc robots, and looking for exact same function as you posted. You mentioned there is a factory made solution for this, but I have trouble locating it. Can you please kindly point out where/ or which manual I should look into?
Thanks.