retobor I ended up converting the points to a user frame and adjusted the frame accordingly. Worked perfect. I appreciate the helpful reply!
Posts by gpphockey
-
-
It is not. I just started writing the program, did not define any frames at the beginning,
-
I am currently running a program on a Fanuc 100ic that is 715 lines long. It is a surfacing pad with 250 welds and calls a torch reaming program periodically throughout.
In the past when creating surfacing pads I used the Program Adjust function between each run to raise the program up in the Z axis 3mm. When trying to use this same method with this program it tells me the amount of positions is too large to save.
Does anyone know a workaround or solution to this problem? Would be much appreciated.