Posts by red0eye

Hey sorry for the long wait,

i had a lot of work and i can only work on the robot in my spare time but i realy want to get it working... i have so much ideas for it

i think i did this before i started the thread... so everythig you see should be standard i just typed in the things i knew with zrobot function...

I'm sorry i know this is super stupid! and it cost me a bit of time and anger to jump over myself...

This is also why i asked you how to enter the basic setup for example how to set servo type (all 900 functions) I have the initialization sheet which should have all the information but i don't know how to enter it...

Also while cleaning its possible i stepped on a cable to the robot... can a cable breakage to the robot cause this?

Can i use the same serial connection which is connected to a floppy drive for the pc serial port`?

Thank you again very much for your help!

best regards

Simon

but i have no backup... how to apply these settings?

AUX 90

initialization

Good Morning,

sorry i was to tired yesterday!

software intitialization or hardware with pin 8?

Ah yes i checked everything which is not 9xx and corrected it as written on the intialization sheet.

Thanks again for your help!!!

here also the main screen: (same error...)

here with a flash to see the rest.

hey so 2 Green LED's

Initialization protocol 2 of 2

Initialization protocol 1 of 2

I/O board. I left it outside now for testing and it the software says cant find I/O port which is correct.

LEDs from the 1GA board

1GA Board

also at startup red led on the left is on but stops after bootup.

So i found the original initialization sheet!

Do you know how i can check the settings from 9xx functions?

I reconnected everything at the 1GB board the bottom led is blinking the upper led is constant on.

i think this is the problem it should be a002 not a001 is there a difference?

cheers so far!

AUX 90

I just replaced the encoder batterys, the ram baterys had no error before...

i just went to a college to get one but its male male

so no computer connection for today...