Has anyone ever encountered the error shown in the image below? I'm trying to set up PROFINET communication between a Siemens S7-1200 PLC and a KUKA KRC2 ed05 robot. The PROFINET IO option is installed, and everything has been configured according to the PROFINET CP1616 manual, but I’m still getting this error.
Kuka KRC2 ed05 Configuration error I/O driver PNET
-
menja97 -
May 16, 2025 at 12:16 PM -
Thread is Unresolved
-
-
That's the generic error message for PN. That message, for any comm driver, most often occurs when the device and the config file disagree on the number of bytes to be transferred. It can also happen if there's an IP address mismatch. There should be additional messages with more details.
Advertising from our partners
