I am trying to set up communication between a KUKA robot with a KRC2 ed05 controller and a Siemens S7-1200 PLC via PROFINET. The robot has a CP1616 card physically installed, but unfortunately, I don't have the driver for it, as can be seen in the images below. What do you recommend?
KUKA KRC2 ed05 robot communication with PLC Siemens S7-1200 PLC
-
menja97 -
May 13, 2025 at 2:08 PM -
Thread is Unresolved
-
SkyeFire
May 13, 2025 at 2:12 PM Approved the thread. -
-
Lemster68
May 13, 2025 at 2:15 PM Approved the thread. -
You could check with KUKA.
Send them the serial number of your robot. They can check what was originally ordered.
IF Profinet was included You normally get the disk (as Repair).
As Fubini mentioned in Your other thread you can not get it as new
Advertising from our partners
