Ghost Image of IRC5 ABB flash Disk

The boot files of my robot flash card (IRC5) With 256 MB has a problem and the operating system does not boot from the flash. While flash is not a problem.

Does anyone have an image file that can be sent to me through a link?
To restore the image, do I need to get a CF to PCMCIA converter or are common USB to CF media is suitable for this?

This is the story of my problem

At first we have bought a second hand robot .when we turn on the controller we have seen some fault on the controller. So I decided to run X-Start to install new system ID on the robot controller. After selecting X-Start, system went to restart state and wants a password to continue this procedure!!!

I wanted to connect robot install to the service port.my pc wasn’t able to connect to the controller and shows some error like system wasn’t able to connect to the pc. I don’t know service port has relation to ABB Password is set or not!!! A little bit strange.

After that I have used command uas_disable to deactivate temporary user authorization system via hyperterminal but although this system did its job, unfortunately the requested password was not reset and I was still involved in this matter.

So I didn’t no way. I have thought is better a test like this:

I have attached the ABB flash Disk to a USB universal card and tried to get image (Clone) of this flash card with Acronics True Image 2021 to get the complete partition image (two different partition ) Root plus user data partition . After that I decided to one more test, to recover images to this flash disk.

I don’t what happened exactly after that I get problem as I told before in this tread.

The robot ware system is ROBOTWARE_5.09.5004 and at in felexpednet system is searching for robot controller but cannot approach to it .maybe I have used wrong software and hardware to take clone of flash disk.

yes I am sure I have done the Ricky procedures .

one more question!!!

If I find a another ABB flash Disk ,can I clone it and transfer it to my flash disk with same size?

I know the system ID will be difference between my system. But I am sure it hasn't a password so I cam select x-start and try my system ID !!!!

What is the best program image tool for this reason ?

should I use old note book with PCMCIA port ?

Please help if somebody has some more information regarding this issue.

Hello Skooter

I know 007 is default one ,But if some body has change it to another one as my robot controller, you don't able to install system ID or other jobs.

I didn't get my answer regarding sufficient imaging tool for clone ABB flash disk?

Thanks