Line Offset

    Hi,

    I am working program with offset. I will fill 100x100mm in area. For example i want to save two point like line. This line should replicate itself at intervals of 10mm in the x or y direction according to the value I specify. It should also stop once it reaches the given width value. How can i write this program on teachpendant?

  • Lemster68 January 28, 2025 at 6:46 PM

    Approved the thread.

    Not sure if this is what you're looking for, but this should work as a concept.

    1: R[1]=0 ;
    2: PR[1,1]=0 ;
    3: PR[1,2]=0 ;
    4: PR[1,3]=0 ;
    5: PR[1,4]=0 ;
    6: PR[1,5]=0 ;
    7: PR[1,6]=0 ;
    8: ;
    9: LBL[1] ;
    10: ;
    11: OFFSET CONDITION PR[1] ;
    12: ;
    13:L P[1] 2000mm/sec FINE Offset ;
    14:L P[2] 2000mm/sec FINE Offset ;
    15: ;
    16: IF (R[1]<100) THEN ;
    17: ;
    18: R[1]=R[1]+10 ;
    19: PR[1,1]=R[1] ;
    20: ;
    21: JMP LBL[1] ;
    22: ;
    23: ENDIF ;

Advertising from our partners