Hello
I recently acquired a used old ABB IRB 1400 robot with an S4 controller. While the robot powers on and seems functional, the seller did not provide the boot disks. When attempting a cold start, I encounter the following message:
"Enter boot disk and press any key."
I contacted ABB support, but they no longer provide support for this system.
I’ve also attempted to create boot disks using files found online, but I received the error:
"This is not a boot disk!!!!"
I suspect I might be missing key files or writing the floppy disks incorrectly, but I’m not sure. I am a little lost.
The serial number from the controller was erased but I will attach numbers from the electronics that maybe can help.
What files should I use for this ABB and how can I create a bootable floppy disk?