I have a round casting about 6" in diameter that has a small boss along the outside of the part. This isn't large enough to accurately get angle data with a GPM tool. My thought were to use the combination tool and find the center of the part with one GPM locator and the small boss with a second GPM locator and construct a line between the two points. I believe I was successfully able to do this and get very repeatable angle measurements. I am looking for a way to use the X and Y position from one GPM locator tool and combine that with the angle results from the constructed line. I'd greatly appreciate any pointers on how to accomplish this.
Fanuc IR Vision combination locator
-
jcmcw -
January 16, 2025 at 6:07 PM -
Thread is Unresolved