hello Everyone
I am creating cell in Roboguide with fanuc M710ic/50T, but there are configuration conflicts. I dont know how to resolve or which configuration need to select.
Roboguide configuration conflict
-
Abhi2024 -
December 27, 2024 at 9:39 AM -
Thread is Unresolved
-
massula
December 27, 2024 at 10:25 AM Approved the thread. -
If you're talking about the software options you can select it usually has a review page that tells you which options you need to change or which options you need to add to make the ones you've already selected happy.
-
Thank you for reply, where to find this review page?
as if you can see below image for error
-
That is the review page
Thank you for reply, where to find this review page?
as if you can see below image for error
You need to go back one page to "8" and add the R651 option and then it should work
Advertising from our partners
