Hello everyone.
I'm trying to open a workcell that refuse to open because of the "Application Tool (H552)
My version of RG is the following : Version 9 (Rev. L) , Licence Registred.
Those following informations has been made :
Open the cell as "run as administrator"
Re-installed RG as administrator ,
Re re installed again a newest version of RG (as administator of course)
Move the cell into all fanuc project ( workcell )
the project is 1 year old so I'm pretty sure I've a version of RG that should support this project.
I can open/edit/save any other project but this one
Any advice?
