Hi all,
I took a look to the manuals but wasn't able to find any description on how to change the values of incrementel jogging.
Is it possible at all? Is there a way using the SmartPad? Or do I actually have to alter the file c:\krc\user\SmrtrHMI.User.config? And if I have to alter the file directly, how to do it? I can't see the file in WoV. 
Many questions. Thanks for any answer. 
Jörn
C:\ is the primary partition on the robot HDD. it contains a lot of files.... some 10Gb or so. most of them do not make it into WoV project....
WoV project is a document (like MS office documents).
It is not an application or operating system so it does not contain everything that may be found on C:\
so if you want to access that file, you will need to look on the robot controller.... or... image of the robot HDD.
Hi panic mode,
so if you want to access that file, you will need to look on the robot controller....
You mean like in "connect a screen, a keyboard and a mouse to the controller and boot to windows"?
or... image of the robot HDD.
It's also part of an archive. This is where I found it.
You mean like in "connect a screen, a keyboard and a mouse to the controller and boot to windows"
why so complicated....
grab smartPad, login as expert, navigate to file...
It's also part of an archive. This is where I found it.
then why was the reason to bring WorkVisual into discussion?
there are different forms of backup. each form collects different set of file. one can make changes using suitable backup but the process is not the same.
for example using archive, you can modify content and then restore modified archive. but.. most people are not good at paying attention and keeping things in correct place within archive so making changes this way has backfired more than once.
why so complicated....
grab smartPad, login as expert, navigate to file...
Because the last time I worked with KUKA was "some years" ago. 
Thanks for the tip. Being able to minimise the HMI had almost slipped my mind.
then why was the reason to bring WorkVisual into discussion?
Because I was hoping that I could do this via some "fancy menu"!? 
should be able to do it from HMI, without need to minimizing it or using windows explorer/notepad.
should be able to do it from HMI ...
You are right. Thanks again!
I'm afraid the last (almost) 3 years with FANUC have messed me up. 
