Flashing Error in KSD1 and KPS600 drives on KRC2 control cabinet

Hello. I need help with the flashing light error on the KRC2 electrical cabinet. My KRC2 cabinet has a flashing light error on the KSD1 and KPS-600 drives, and the screen shows some errors (I did not save to post here). The supplier's engineer informed that the hard drive had a data error and they sent a Ghost image for me to Ghost the data again. After Ghosting the new data, (The software version has been upgraded from 5.4 to 5.5.) The Serial number in the machine's RDC has been reset to 0. However, this error has not been resolved. In addition, there are some errors after I Ghost the data again (as shown in the attached image below). Unfortunately, the supplier's engineers are currently busy with the exhibition event and do not have time to support me, so I have to post it here in the hope of getting help. Thank you very much everyone.