check firewall from PC which always is the first thing you need to check.
then you must also select the correct pseudo.
then you must also select the correct pseudo.
Hi Potis,
Thanks for your suggestions.
Are you referring to PSEUDO INPUT#82015? If yes, I have already activate it.
About the firewall, I can ping to the address correctly(no packet loss).
We use DCI on our xrc. What system do you use? I remember seeing similar errors. I can get similar error if i try to save a file that's not on the controller or load a file not on the pc. I sort of remember having the same issue where none of the cmds worked. Not sure what the cause was, it was quite awhile ago. Im pretty sure it was something simple
PC Card under device for saving on the controller? Proper path set in DCI?
communication settings
19200 baud
8 data length
1 stop bits
even parity
com port 1
Not sure what controller your using or if it matters but these are the settings on our system.
if your robot has 192.168.100.10 and computer 192.168.100.11 do the following
RS000=2
RS005=0
RS007=0
IO=>Pseudo Input=>Command Remote=OFF
And you have to specifiy the pc s IP address where MotoDCI is installed in parameters (RS82-RS85) or in maintenance mode (Ethernet settings=>server ip)
RS070=192
RS071=168
RS072=100
RS073=10
RS074=255
RS075=255
RS076=255
RS077=0
RS078=192
RS079=168
RS080=100
RS081=1
RS082=192
RS083=168
RS084=100
RS085=11
