Hi,
I am new with Panasonic robots.
we have a controller and manipulator with this code:
YA-1UAR + TA1400
it have an alarm on the pendant. can help for it?
RE over speed error
-
TSGIR -
October 22, 2024 at 11:49 AM -
Thread is Unresolved
-
You must conncect jumper on the robot whit power on to reset axis.
There are batteries and jumpers on the robot under the cover on 1 axis.
Remove the cover and make a jumper for the UA axis to remove the error.
After restarting, calibrate the robot using the arrows and later make pin calibration.
Where are You form?? Because my english is not very good.
Advertising from our partners
