I am currently working on a pillar robot project that is connected upside down to a gantry (similar to Jithin T Sunny's video on youtube)
I just started learning roboguide about a month and need help with the set up for the basics of this project
Send Help!
First step would be posting in the correct forum.
There is a detailed guide in the Roboguide help that goes over the rail creation process.
If you installed the example workcells, there is an example in there.
Thanks for the rapid response!
Roboguide help only covers the parts of x-y plane for auxiliary axis, but what i need is a base for my robot that is able to move it on x-y and z like a real gantry does.
I also don't know how to make rails for each plane and roboguide help does not conduct these problems
correct me if Im wrong
Have you gone through the procedure for adding the axes to the X and Y planes? In the help, "Building an aux axis system example Step 2 Build the auxiliary axes system" goes over the setup quite clearly.
I did
Whenever I add the 3rd axis on Z plane, rail roads goes nuts and system dissassambles
I know it sounds strange but I dont know how to explain it in another way 
Screenshots, or posting the compressed cell would help a lot.
I decided to see if I could knock this out. Compressed roboguide cell attached.
