hi everyone,
When i load a backup on my robot and after i put de dcs parameter it gave me this error (svro-337) and i didn't understand what those mean ?
and how i can fix it ?
thanks in advance
Transferring an “all of above” backup
-
Gauthier -
July 17, 2024 at 8:43 AM -
Thread is Unresolved
-
Go to DCS Menu and Press APPLY (F2) and enter the DCS password, wait a few seconds for the next screen to appear and then press OK. Cycle power to the controller and this alarm should be gone.
-
For SRVO-337
Cause:
DCS parameter error is detected. When an image restore is done and 'No' is selected for initialize DCS parameter, if the previous DCS parameters are different from what is in the image file, this alarm occurs.Remedy:
1. Do an APPLY of the DCS parameters if an image restore was done. 2. If power down occurred while DCS parameters were being changed, set the DCS parameters again. 3. Load backup files. 4. Replace main board, CPU card, FROM/SRAM module.
Advertising from our partners
