New system does not load

    Code
    Hello everyone, I have the following problem on robots model irc5. I'm creating rw5 systems from existing robot backups and trying to install on a flash compact that I applied x-start. However, when installing the new system, when restarting the controller loads the new system's loading screen, from that moment it hangs in the middle of loading and restarts to the bios without any system installed. I also noticed that after installing the system, none appear in the installed systems tab. I noticed that the rw of the backup being created was 5.13.10 and my rw was 5.15. I then tried to create the system from rw 5.13.30 but the same thing happened.

  • MOM June 12, 2024 at 2:05 PM

    Approved the thread.

    Canyou X-Start the IRC5 and see if there are already systems on the Compact Flash?

    Also, if you are able to get to the Boot Application you could set an IP up for the LAN port and ftp to the CF and see if there is a problem.

    Finally, if the CF is a clone, good luck. VxWorks (the control kernel) is very difficult to get working as intended.

    tutorial Ghost ,its the first i found on youTube

    External Content www.youtube.com
    Content embedded from external sources will not be displayed without your consent.
    Through the activation of external content, you agree that personal data may be transferred to third party platforms. We have provided more information on this in our privacy policy.

    ghost is a program that copies and writes partitions on hdd.
    Put the NEW CF Card in the USB adapter and write the partition with the Ghost program.
    Now you will have ONE bootable CF card for Robot Irc5.
    The card will NOT contain any System, you will have to install it, thus eliminating the possibility that your Cf Card is corrupted

    Irc5_Ghost.zip

    BUY A NEW CARD

    Edited once, last by Black (July 1, 2024 at 11:37 AM).

Advertising from our partners