Hi guys.
On the site is compact-plus fanuc robot, but ip conflict.
I need for commisioning and for future buy the TP cable.
We have TPs but this cable connected direct to inside agregate, not out connector for connect.
Any advice for buying it ? We are slovak region.
Thank you.
You can buy a TP cable with suitable connectors on both sides directly from FANUC. Tomorrow I can send you the correct part number.
There is a procedure for setting the IP address without the pendant.
It involves creating an .xml file, placing it on the usb stick, and then rebooting the robot. Section 14.35.3.5 of the MAROUHT9102171E Rev E manual goes over it.
If you want to go with the TP solution, the part numbers for the TP cable are:
- A05B-2690-H200 (length 5 m)
- A05B-2690-H201 (length 10 m)
- A05B-2690-H202 (length 20 m)
You will find this information in the R-30iB Compact Plus maintenance manual (e.g. B-84035EN/04).
If no TP was ordered to the robot, it should have iRProgrammer, and then you might be able to access the TCP/IP-settings through it.
You can use the iRProgrammer from the robot homepage.
