DCS : User Model and tools change

Hi everyone,

I'm relatively new on Fanuc Robots so excuse me if my questions are obvious.

I'm facing a problem concerning my DCS configurations on my R2000iC/270F with R30iB controller.

I successfully created CPC Zones and an user model the shape of my tool. Therefore, my tool can't get into the zones.

But i will have to use two differents tools with different geometries so i'll need to create another User model for it.

The problem is that i don't understand how to associate my user models to my tools. I would like to have only the usermodel from tool 1 when i'm using tool 1 and usermodel 2 when i'm using tool 2.

Can someone explain me how to achieve it ?

Thank you for any help !

I didn't know they were interface for DCS, i though it was only software. Maybe i do but how to figure it out ? There is nothing for DCS in the controller.

You mean that i'm suppose to have an interface on which i hardwire signal to select the tools i'm using ?

Thanks,