we have anybus bolts in use with our mobile machines, but pretty much any wireless accesspoint can be configured to do that
Anybus Wireless Bolt - Ethernet RJ45 PoE
but why can´t you run ethernet? do you have wireless power connections for your robots?
either way you connect the wan-port and configure it according to the manual, for more then just ftp you need the 616-1 PC Interface option
i used a minirouter wifi, Router Wireless N 3G/4G , TL-MR3020,on LAN configurate with robot ip
on wireless your wireless config.
you will be able to conect one by one ,not to all toghether
if you dont have pc interface option,
i used a smal relay comanded by PLC ,so you don't have network conflict
so when i need to connect to rob 1 ,i actived relay and i have power on router 1
hello experts !
now i have more than 10 ABB robots, and their positions are hard for me to use ethernet connection (i want to connect all robot at the same time)
so, i use wireless connection (wifi). but i don't know how to setup wireless connection for ABB robot
pls tell me how to do it, thanks so much
Connect all robots to an ethernet switch from the wan port. Provide internet to the switch port. When you connect to wifi, you can scan and find robots. WAN addresses should not be the same, they should be in the same space.
192.168.1.1 - modem,
192.168.1.10 - r1
192.168.1.11- r2
...
etc.
