Greetings of the day everyone .
This is my first time connecting a EOAT to a REAL ROBOT of Fanuc 2000ic 125L of R30iB plus Controller.
Network Block - Balluff [ BNI008P ]
Valve Bank - Parker [ P2M2HBVE12400 ] [picture shown Below ]
I given IP address to Network Block and Valve Bank and I PING Successfully with the teach pendent. Iam not getting the Power LED ON to it , so that i can toggle with DO ,
Sorry , if its a dumb question .
I dont know how to set up in the DO to toggle the Specific gripper cylinders to Clamp and Unclamp and am I missing something for the power ? because the power to the Valve bank is getting from Balluff and its works fine and i even changed the Power cable too , but no luck .
Any other steps iam missing to trouble shoot ?
Please help me , thank you
