Board JANCD-YCP01-E

    Hello, is it possible to retrieve robot data via the LAN port (CN104)?

    How to configure its IP address?

    I have already been in maintenance mode, function/option, network, host conf.. but nothing happens ... My PC does not detect the card

    Yes, it is possible. There are several packages you could purchase to accomplish this. At a bare minimum you would need a software option turned on and parameters adjusted.

    I, personally, don’t know if I would bother on a 10+ year old controller.

    I know a thing or two, because I’ve seen a thing or two. Don't even ask about a third thing. I won't know it.

    J'ai réussi la manipulation, il faut juste activer la "transmission de communication" via le fichier ALL.PRM

    Ce n'est pas parce que le matériel est vieux qu'il faut le changer.

    La base en robotique c'est d'être curieux et établir toutes les possibilités avant penser aux remplacements du matériels.

Advertising from our partners