Simulation of UOP IN signal without PLC

  • Hello everyone,


    I'm looking for guidance on simulating UI ON/OFF functionality. I attempted to configure it on rack 34, with the intention of using flags to control the ON/OFF states. Unfortunately, I'm encountering a problem where the Start, Prod Start, and RSR signals immediately turn off after the flags are set to ON. Does anyone have a solution for successfully turning them ON and OFF?


    Thank you.

  • Place your Ad here!
  • kwakisaki

    Approved the thread.
  • Flags work, show your code. Are you controlling the flags in a BG Logic program?

    I did not use them in BG because I did not find a solution for pulsing a flag in BG logic. All I'm testing now is the ON/OFF functionality on the I/O Screen. I conducted the same test on my robot and found that it works correctly, suggesting that the issue may be specific to RoboGuide.

    I'm curious about how you are pulsing the flags to send signals ?
    NDArgR4TlSgYP3e

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account
Sign up for a new account in our community. It's easy!
Register a new account
Sign in
Already have an account? Sign in here.
Sign in Now

Advertising from our partners