NX100 / FRONIUS POWER SUPPLY MISSING CABLES

  • Hello all, the company I work for just bought a used Motoman NX100 weld cell with Fronius 3200 power supply however when it got here we realized it was missing some cables. They are the cable / cables comes out of the back of the power supply X91port and splits off into a pig tail. One side of the pig tail runs to port CA34 on the NX100 controller, the other runs to a connector at the robot for the vr5000 wire feeder. We have another robot with this cable but I cannot find any ID markings on them. Motoman claims they don't know the P/N since it is a fronius cable. I contacted Fronius and they have been of no help either. We just need that cable to get up and running. I am frantically looking for it. Worse comes to worse I will try to find the backshells and pins and make one but I'd like to keep that for last resort. Can anyone help me out?


    Thank You

Advertising from our partners