So, I'm about to go to a customer site to install a PAC code for a new option they've ordered. But it turns out, no one knows where the original core-load USB stick is (they're still looking). Now, as I understand it, activating a new PAC code requires having the original core-load USB in UD1. If the original USB (or copy of) cannot be found, what are my options? Am I stuck asking Fanuc for a fresh copy of the original core-load?
Add PAC code without core-load USB
-
SkyeFire -
September 1, 2023 at 4:34 PM -
Thread is Unresolved
- Go to Best Answer
-
Yes, you need it. Contact Fanuc asap. They will burn a new USB drive for you for a fee, but it can take a few days. If you need it quickly for your trip then make sure they know it is urgent.
-
I don't think reburns are free they usually cost 650 dollars.
-
Right I said for a "fee" not for free.
-
I --think-- it might be possible with an auto update USB. Long shot, but worth a try if you don't have the original USB media.
-
Sorry I was not wearing my glasses.
-
I --think-- it might be possible with an auto update USB. Long shot, but worth a try if you don't have the original USB media.
Yes, I would also give this a try.
-
Well, the good news is, the customer found the original core-load USB. So I dodged that bullet.
For future knowledge, what's an auto-update USB?
Just the auto update from Fanuc on a USB drive.
-
Just the auto update from Fanuc on a USB drive.
Which may just be available for free to download by registered users
-
- Best Answer
The same situation here..
Mine controller is r-i30b V8.30p/20
and i don't have the original installation usb
but i have V8.30P71_Auto_Update.
Can install from this auto update?
--update--
I have installed V8.30P71_Auto_Update
and after that i have installed some free options so i supose that from auto update
can install software options without original installation usb.
Advertising from our partners
