Hi, i have extend and retract CAD file of my EOAT , but i need some help to simulate the movement of extend and retract of cylinder of EOAT
Simulation of actuator at EOAT
-
amin12 -
August 28, 2023 at 8:46 AM -
Thread is Unresolved
-
kwakisaki
August 28, 2023 at 9:39 AM Approved the thread. -
Welcome to the forum.........
It depends on whether you want to simulate the actual travel motion of the models or if you just want it snap between 2 states.
The easiest method is to snap between 2 states by applying the OPEN and CLOSE method which uses your 2 models of 'extend and retract'.
The attached video shows a simple setup using stock models in Roboguide.
You can apply the same process with your EAOT Models.
Advertising from our partners
