I have programmed a position to a DO but would also like that position to light up on the Operator Panel as USER 1 button as an indication of that position.
This is for R-J3iB.
How can I do this?
How To Program SOP I/O to light up when Position Reached
- ducks09
- Thread is Unresolved
-
MOM
Approved the thread. -
MOM
Moved the thread from forum General Discussion of Industrial Robots Only to forum Fanuc Robot Forum. -
Hi ducks09,
R-J3iB does not have BG-LOGIC or FLGs.
So it's not that easy.
You can write a second task/program that will run in background.
This program has to monitor your DOUT[x] and sets the corresponding TPOUT/SOP...
But I don't recommend that, because of "multi tasking power" of RJ3iB...
---
idea: It's an old controller. so wire up your DO to the User Push Buttons LED.
---
-
I'm not familiar with R-J3iB specifically, but iIf it is for only one, or a few positions I would set up a reference position. You can tie a DO directly to a reference position.
Advertising from our partners
