shaking arm on short distances movement

    Hi

    I wish to know if is normal Kula robot arm to have some shaking when moving on a short toolpath code line C_DIS, milling a curved shape, if feed rate is more than 3000mm/min.

    I think is from need to brake at each end and start on short curved toolpath.

    Except low feedrate, what else could make movement smooth?

    Is a krc4 kss 8.3.19.

    Thanks

    not sure what your program looks like, what motion instructions are used, what the motion parameters are, if the load is correct etc. also there is no indication of the magnitude of the oscillation, robot arm position when it is observed...


    3000mm/min is only 50mm/sec which is quite low speed.


    btw, few years ago i have seen some oscillations in cases where robot was near Alpha1 singularity (consoler robot mounted on an angle, and TCP was below robroot). so problem was sorted out by KUKA support after presenting trace and video of the issue. they provided instructions to manipulate value in MADA and disable elasticity compensation. after that thing was solid.

    1) read pinned topic: READ FIRST...

    2) if you have an issue with robot, post question in the correct forum section... do NOT contact me directly

    3) read 1 and 2

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account
Sign up for a new account in our community. It's easy!
Register a new account
Sign in
Already have an account? Sign in here.
Sign in Now