RSR to Style start method

    I am currently working with 3 R30ia controllers with ArcTool on them. 2 of these controllers are setup to start using the Style method, and one is setup using RSR. I thought it would be as simple as changing it from RSR to Style, and picking the program I wanted to start for my Style, but that didn't seem to work. I suspect I'm missing something in the ArcTool Setup manual.

    My goal is to have a "Main" program that is then used to call other programs for the parts that are running, or torch clean cycles, etc. I would like that "Main" program to run every time the Cycle Start input on the UOP panel is pressed.

    Any help or suggestions would be greatly appreciated.

    Thanks.

  • SkyeFire April 1, 2023 at 3:08 AM

    Approved the thread.
    • Best Answer

    If you want 1 main program than the "Other" method is the correct choice. Other mode let's you select a single starting program, by clicking on detail in the Prog select menu.

    If other mode isn't available then I recommend using PNS and making PNS001 your main program.

Advertising from our partners