As the subject says, the System/Config screen for my R30iA (HandlingTool V7.70) is missing the Program Select and Production Start options from the System/Config screen. Also, Remote/Local setup reverts to "OP panel key" after a cold start. I'm working in Roboguide with a backup of the actual robot, which is just over 1000 miles away right now. Is there some sort of system variable I need to enable?
Program Select Method missing from System/Config screen
-
TitusLepic -
March 10, 2023 at 5:00 PM -
Thread is Resolved
-
Program select is under setup. I thought I had the same issue but it was just under a different name for me due to using a different software.
Advertising from our partners
