Moving Devicenet I/O and data to another robot.

    How’s everybody doing?


    I had a question I’m really hoping you guys can help me figure out; I’m a robotic laser processing engineer and need help figuring how to transfer Devicenet data from one robot to another. We’re using a Trumpf Trudisk laser with no PLC; when I set this robot up, I had to manually enter the names of all the I/O and everything— since I’m communicating with the same laser, can I just copy over all the I/O and the names so that doesn’t have to all be manually entered?


    Any answer is greatly appreciated, I hope this question finds you guys well and in good health.

    Post
    RE: I/O description
    VA files are not loadable, don´t waste your time with the strange structure of this one. Save the DIOCFGSV.IO from RG and load into your robot, enjoy. Take in mind that the i/O config is also included in this file, not only comments.
    rob76

    My apologies, I was off from work the last few days of last week and forgot to check back to this thread.


    When I backup the DIOCVGSV.IO variable, will that automatically sync to my Trumpf Trudisk laser? Or do I have to go through and set the communication up for that robot still? My apologies if that’s a dumb question, I’m newer to this field.

Advertising from our partners