Hi, we have recently started doing longer weld runs on our Motorman robot and are having trouble with the shroud getting to hot, it's melting the orings on the defuser. Just wondering if there is anything we can do to try and keep the torch cooler?
Welding torch setup
-
T STUDS -
November 16, 2022 at 6:56 PM -
Thread is Unresolved
-
SkyeFire
November 16, 2022 at 7:36 PM Moved the thread from forum General Discussion of Industrial Robots Only to forum Yaskawa Motoman Robot Forum. -
If you are currently using an air-cooled torch, then you might want to look at using a water-cooled torch.
Advertising from our partners
