I have a fanuc 30ib can remember the actual model but I'm trying to touch up a couple of weld points and it keeps going back to the original position and not to the new position, it's almost like it's just not taking the new position. Has anyone ran into this before or am I just over looking something?
Touching up spot points
-
Casto2012 -
November 11, 2022 at 10:46 AM -
Thread is Unresolved
-
-
Is it a position register that you are touching up?
It's probably being overwritten by your code. If you could post your code, that would really help.